Technical Service

How to correctly select a decanter centrifuge


summary : How to correctly choose a decanter centrifuge
  How to correctly select a decanter centrifuge
 
  The centrifugation separation time for adding materials to the decanter centrifuge. If necessary, several repeated dehydration methods can be used to reduce the amount of material dehydrated and filtered in each three-phase decanter centrifuge to ensure solid-liquid separation. Pre-treatment is very important, and viscous substances are separated and treated. Pre-treatment operations such as washing should be stopped within the allowable range of the process.
 
  At the same time, different raw materials will affect the service life of the three-phase decanter centrifuge, so we should choose a three-phase decanter centrifuge with good raw materials. The three-phase decanter centrifuge expands the separation and processing capacity of the horizontal spiral centrifuge by relatively improving the particle size of the solid material. Under the condition that the process remains unchanged, the use of flocculants, coagulants, precipitants and other agents can be considered to improve the separation capacity of the three-phase decanter centrifuge. We should pay attention to the differential control of the three-phase decanter centrifuge. If the differential speed of the horizontal spiral centrifuge is very low, it is easy to affect the operation, so we should choose a high-precision three-phase decanter centrifuge, and the horizontal spiral discharge centrifuge is also. After welding of the three-phase decanter centrifuge, the bevel and surrounding area within 25 mm must be subjected to strict mechanical cleaning and degreasing treatment, and corresponding maintenance measures should be taken to prevent the bevel from being contaminated during the entire welding process.
 
  Before pre-welding, the corresponding maintenance methods should be prepared in advance. If conditions permit, an iron contamination test should be carried out in advance. During the welding process of the three-phase decanter centrifuge, the color of the weld layer should be checked after each welding. Under normal circumstances, the appearance color of the weld and heat affected zone should be snow-white or golden yellow. If the color does not match, welding should be stopped again.